Reference Guide

1310 | Security
www.dell.com | support.dell.com
show dot1x interface
c e s
Display the 802.1X information on an interface.
Syntax
show dot1x interface interface
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC privilege
Command
History
Example
Figure 51-5. show dot1x interface command Example
SSH Server and SCP Commands
FTOS supports SSH Protocol versions 1.5 and 2.0. Secure Shell (SSH) is a protocol for
secure remote login over an insecure network. SSH sessions are encrypted and use
authentication.
• crypto key generate
interface
Enter one of the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Fast Ethernet interface, enter the keyword FastEthernet followed by the
slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
Version 7.6.1.0 Introduced on C-Series, E-Series, and S-Series
FTOS#show dot1x int Gi 2/32
802.1x information on Gi 2/32:
-----------------------------
Dot1x Status: Enable
Port Control: AUTO
Port Auth Status: UNAUTHORIZED
Re-Authentication: Disable
Untagged VLAN id: None
Guest VLAN: Enable
Guest VLAN id: 10
Auth-Fail VLAN: Enable
Auth-Fail VLAN id: 11
Auth-Fail Max-Attempts: 3
Tx Period: 30 seconds
Quiet Period: 60 seconds
ReAuth Max: 2
Supplicant Timeout: 30 seconds
Server Timeout: 30 seconds
Re-Auth Interval: 3600 seconds
Max-EAP-Req: 2
Auth Type: SINGLE_HOST
Auth PAE State: Initialize
Backend State: Initialize
FTOS#