Reference Guide

Control and Monitoring | 131
show processes ipc flow-control
c e s
Display the Single Window Protocol Queue (SWPQ) statistics.
Syntax
show processes ipc flow-control [cp | rp1 | rp2 | lp linecard-number]
Parameters
* In the S-Series, this command supports only the cp keyword, not the rp1, rp2, and lp options. See
Figure 5-46.
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
show hardware system-flow Display Layer 3 ACL or QoS data for the selected stack member and stack
member port-pipe.
show interfaces stack-unit Display information on all interfaces on a specific S-Series stack member.
show processes memory
(S-Series)
Display CPU usage information based on processes running in an S-Series
cp (OPTIONAL) Enter the keyword cp to view the Control Processor’s SWPQ
statistics.
rp1 (OPTIONAL) Enter the keyword rp1 to view the Control Processor’s SWPQ
statistics on Route Processor 1.*
rp2 (OPTIONAL) Enter the keyword rp2 to view the Control Processor’s SWPQ
statistics on Route Processor 2.*
lp linecard-number (OPTIONAL) Enter the keyword lp followed by the line card number to view the
Control Processor’s SWPQ statistics on the specified line card.*
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series and E-Series