Reference Guide

1296 | Security
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Mode
CONFIGURATION
Command
History
radius-server deadtime
c e s
Configure a time interval during which non-responsive RADIUS servers to authentication requests are
skipped.
Syntax
radius-server deadtime seconds
To disable this function or return to the default value, enter no radius-server deadtime.
Parameters
Defaults
0 seconds
Command Modes
CONFIGURATION
Command
History
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number from
zero (0) to 16838.
• For the Null interface, enter the keywords
null 0.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.2.1.1 Introduced on E-Series
seconds
Enter a number of seconds during which non-responsive RADIUS servers are skipped.
Range: 0 to 2147483647 seconds.
Default: 0 seconds.
Version 7.6.1.0 Introduced for S-Series
Version 7.5.1.0 Introduced for C-Series
pre-Version 6.1.1.0 Introduced for E-Series