Reference Guide

1270 | Rapid Spanning Tree Protocol (RSTP)
www.dell.com | support.dell.com
protocol spanning-tree rstp
c e s
Enter the RSTP mode to configure RSTP.
Syntax
protocol spanning-tree rstp
To exit the RSTP mode, enter exit
Defaults
Not configured
Command Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Example
Figure 50-2. protocol spanning-tree rstp Command
Usage
Information
RSTP is not enabled when you enter the RSTP mode. To enable RSTP globally on the system, enter no
description from the RSTP mode.
Related
Commands
show config
c e s
View the current configuration for the mode. Only non-default values are displayed.
Syntax
show config
Command Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Example
Figure 50-3. show config Command for the RSTP Mode
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced for E-Series
FTOS(conf)#protocol spanning-tree rstp
FTOS(config-rstp)##no disable
description
Disable RSTP globally on the system.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced for E-Series
FTOS(conf-rstp)#show config
!
protocol spanning-tree rstp
no disable
bridge-priority 16384