Reference Guide

1256 | Remote Monitoring (RMON)
www.dell.com | support.dell.com
Parameters
Defaults
No default behavior
Command Modes
CONFIGURATION INTERFACE (config-if)
Command
History
rmon event
c e s
Add an event in the RMON event table.
Syntax
rmon event number [log] [trap community] [description string] [ownername]
To disable RMON on an interface, use the no rmon event number [log] [trap community]
[description string] command.
Parameters
Defaults
as described above
Command Modes
CONFIGURATION
Command
History
controlEntry integer Enter the keyword controlEntry to specify the RMON group of statistics
using a value. Then enter an integer value from 1 to 65535 that identifies the
RMON Statistic Table. The integer value must be a unique in the RMON
Statistic Table.
owner name
(OPTIONAL) Enter the keyword owner followed by the owner name to
record the owner of the RMON group of statistics.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.1.1.0 Introduced for E-Series
number
Assign an event number in integer format from 1 to 65535. The number
value must be unique in the RMON Event Table.
log (OPTIONAL) Enter the keyword log to generate an RMON log entry. The
log entry is triggered and sets the eventType in the RMON MIB to log or
log-and-trap.
Default: No log
trap community
(OPTIONAL) Enter the keyword trap followed by an SNMP community
string to configure the eventType setting in the RMON MIB. This sets either
snmp-trap or log-and-trap.
Default: public
description string (OPTIONAL) Enter the keyword description followed by a string
describing the event.
owner name
(OPTIONAL) Enter the keyword owner followed by the name of the
owner of this event.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.1.1.0 Introduced for E-Series