Reference Guide

Router Information Protocol (RIP) | 1241
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
Related
Commands
ip poison-reverse
c e s
Set the prefix of the RIP routing updates to the RIP infinity value.
Syntax
ip poison-reverse
To disable poison reverse, enter no ip poison-reverse.
Defaults
Disabled.
Command Modes
INTERFACE
Command
History
Related
Commands
ip rip receive version
c e s
Set the interface to receive specific versions of RIP. The RIP version you set on the interface overrides
the version command in the ROUTER RIP mode.
Syntax
ip rip receive version [1] [2]
To return to the default, enter no ip rip receive version.
Parameters
Defaults
RIPv1 and RIPv2.
isis (OPTIONAL) Enter the keyword isis to filter only IS-IS routes.
Note: This option is only available on E-Series.
ospf
(OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
static (OPTIONAL) Enter the keyword static to filter manually configured routes.
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip prefix-list Enter the PREFIX-LIST mode and configure a prefix list.
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip split-horizon Set RIP routing updates to exclude routing prefixes.
1 (OPTIONAL) Enter the number 1 for RIP version 1.
2 (OPTIONAL) Enter the number 2 for RIP version 2.