Reference Guide

Quality of Service (QoS) | 1225
Usage
Information
If a Policy QoS is applied on an interface when clear queue statistics egress is issued, it will
clear the egress counters in show queue statistics and vice-versa. This behavior is due to the values
being read from the same hardware registers.
Related
Commands
clear queue statistics ingress
e
Clear ingress queue statistics.
Syntax
clear queue statistics ingress [unicast [src-card ID [dst-card ID ]] | [multicast] [src-card
ID ]]
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command
History
Related
Commands
show queue statistics egress
e
Display the egress queue statistics.
Syntax
show queue statistics egress [unicast | multicast] [Interface] [brief]
clear queue statistics egress
Clear ingress queue statistics
show queue statistics egress
Display egress queue statistics
show queue statistics ingress
Display ingress queue statistics
unicast [src-card ID
[dst-card ID]]
(OPTIONAL) Enter the keyword unicast to clear Unicast queue
statistics. Optionally, enter the source card identification (
src-card ID)
and the destination card identification (dst-card ID) to clear the unicast
statistics from the source card to the destination card.
multicast [src-card ID]
(OPTIONAL) Enter the keyword multicast to clear only Multicast
queue statistics. Optionally, enter the source card identification
(
src-card ID) to clear the multicast statistics from the source card.
Default: Both Unicast and Multicast queue statistics are cleared.
Version 6.2.1.1 Introduced
clear queue statistics egress
Clear egress queue statistics
show queue statistics egress
Display egress queue statistics
show queue statistics ingress
Display ingress queue statistics