Reference Guide

1104 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
Usage
Information
Do not enter this command before creating the access-list.
ip pim query-interval
c e s
Change the frequency of PIM Router-Query messages.
Syntax
ip pim query-interval seconds
To return to the default value, enter no ip pim query-interval seconds command.
Parameters
Defaults
30 seconds
Command Modes
INTERFACE
Command
History
ip pim register-filter
c e s
Use this feature to prevent a PIM source DR from sending register packets to an RP for the specified
multicast source and group.
Syntax
ip pim register-filter access-list
To return to the default, use the no ip pim register-filter access-list command.
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
The access name is an extended IP access list that denies PIM register packets to RP at the source DR
based on the multicast and group addresses. Do not enter this command before creating the access-list.
seconds
Enter a number as the number of seconds between router query messages.
Default: 30 seconds
Range: 0 to 65535
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series on port-channels and S-Series
access-list
Enter the name of an extended access list. Maximum 16 characters.
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.6.1.0 Introduced