Reference Guide

PIM-Sparse Mode (PIM-SM) | 1103
Example
Figure 41-1. ip pim join-filter Command Example
Related
Commands
ip pim ingress-interface-map
c e s
When the Dell Force10 system is the RP, statically map potential incoming interfaces to (*,G) entries
to create a lossless multicast forwarding environment.
Syntax
ip pim ingress-interface-map std-access-list
Parameters
Defaults
None
Command Modes
INTERFACE
Command
History
Example
FTOSFTOS(conf)# ip access-list standard map1
FTOS(config-std-nacl)# permit 224.0.0.1/24
FTOS(config-std-nacl)#exit
FTOS(conf)#int gig 1/1
FTOS(config-if-gi-1/1)# ip pim ingress-interface-map map1
ip pim neighbor-filter
c e s
Configure this feature to prevent a router from participating in protocol independent Multicast (PIM).
Syntax
ip pim neighbor-filter {access-list}
To remove the restriction, use the no ip pim neighbor-filter {access-list} command.
Parameters
Defaults
Defaults.
Command Modes
CONFIGURATION.
Command
History
FTOS(conf)# ip access-list extended iptv-channels
FTOS(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
FTOS(config-ext-nacl)# permit ip any 232.1.1.0/24
FTOS(config-ext-nacl)# permit ip 100.1.1.0/16 any
FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels in
FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels out
ip access-list
extended
Configure an access list based on IP addresses or protocols.
std-access-list
Enter the name of an standard access list that permits the
Version 8.4.1.0 Introduced
access-list
Enter the name of a standard access list. Maximum 16 characters.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.6.1.0 Introduced on the E-Series