Reference Guide

1092 | Policy-based Routing (PBR)
www.dell.com | support.dell.com
show cam pbr
c e s
Display the PBR CAM content.
Syntax
show cam pbr {[interface interface] | linecard slot-number port-set number]} [summary]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
Command
History
Example
Figure 39-1. Command example: show cam pbr linecard 2 port-set 0
Usage
Information
The show cam pbr command displays the PBR CAM content. The “VlanID” column displays the
corresponding VLAN ID to which the redirect-group is applied.
Related
Commands
interface interface Enter the keyword interface followed by the name of the interface.
linecard slot-number Enter the keyword linecard followed the slot number.
Range: 0 to 13 for the E1200, 0 to 6 for the E600/E600i, 0 to 5 for the E300
port-set number
Enter the keyword port-set followed the port-pipe number.
Range: 0 to 1
summary Enter the keyword summary to view only the total number of CAM
entries.
Version 7.4.1.0 Introduced
FTOS#show cam pbr linecard 2 p 0
TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST, Bit 1 - SYN, Bit 0 – FIN
Cam Port VlanID Proto Tcp Src Dst SrcIp DstIp Next-hop Egress
Index Flag Port Port MAC Port
------------------------------------------------------------------------------------------------------
.
.
.
15230 _ 10 TCP 0x10 0 0 100.55.1.0/24 182.16.1.1/24 N/A N/A
FTOS#
ip redirect-group Apply a redirect group to an interface.
show ip redirect-list Display the redirect-list configuration.
show cam-usage Display the CAM usage on ACL, router, or switch.