Reference Guide

1074 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
Command
History
Usage
Information
The time interval between hello packets must be the same for routers in a network.
Related
Commands
ipv6 ospf priority
c e
Set the priority of the interface to determine the Designated Router for the OSPFv3 network.
Syntax
ipv6 ospf priority number
To return to the default value, use the no ipv6 ospf priority command.
Parameters
Defaults
1
Command Modes
INTERFACE
Command
History
Usage
Information
Setting a priority of 0 makes the router ineligible for election as a Designated Router or Backup
Designated Router.
Use this command for interfaces connected to multi-access networks, not point-to-point networks.
ipv6 router ospf
c e
Enable OSPF for IPv6 router configuration.
Syntax
ipv6 router ospf process-id
To exit OSPF for IPv6, enter no ipv6 router ospf process-id
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Version 7.8.1.0 Added support for C-Series
Version 7.4.1.0 Introduced
ipv6 ospf dead-interval Set the time interval since the last hello-packet was received from a router.
number
Enter a number as the priority.
Range: 0 to 255.
Default: 1
Version 7.8.1.0 Added support for C-Series
Version 7.4.1.0 Introduced
process-id
Enter the process identification number.
Range: 1 to 65535