Reference Guide

1066 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
The configuration of IPsec encryption on an interface-level takes precedence over an area-level
configuration. If you remove an interface configuration, an area encryption policy that has been
configured is applied to the interface.
To remove an IPsec encryption policy from an interface, enter the no area area-id encryption spi
number command.
Related
Commands
-
clear ipv6 ospf process
ce
Reset an OSPFv3 router process without removing or re-configuring the process.
Syntax
clear ipv6 ospf process [process-id]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
debug ipv6 ospf packet
c e
Display debug information on OSPF IPv6 packets.
Syntax
debug ipv6 ospf packet [interface]
To cancel the debug, use the no debug ipv6 ospf packet [interface] command.
Parameters
Command Modes
EXEC Privilege
ipv6 ospf encryption Configure an IPsec encryption policy on an OSPFv3 interface.
show crypto ipsec policy
D
isplay the configuration of IPsec encryption policies.
process-id
(OPTIONAL) Enter the process identification number.
Version 7.8.1.0 Added support for C-Series
Version 7.4.1.0 Introduced
interface
(OPTIONAL) Enter one of the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
C-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to
4094