Reference Guide

Open Shortest Path First (OSPFv2 and OSPFv3) | 1053
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a
specific OSPF process. If you do not enter the Process ID, only the first configured process is listed.
process-id
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For the null interface, enter the keyword
null followed by zero (0).
• For loopback interfaces, enter the keyword
loopback followed by a number from 0
to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by the VLAN ID. The range is from 1
to 4094.
Version 7.8.1.0
Introduced
process-id option, in support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series