Reference Guide

Control and Monitoring | 101
Parameters
Defaults
OFF
Command Modes
EXEC
Command
History
Usage
Information
The LED setting is not saved through power cycles.
send
c e s
Send messages to one or all terminal line users.
Syntax
send [*] | [line ] | [aux] | [console] | [vty]
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
Command
History
Usage
Information
Messages can contain an unlimited number of lines, however each line is limited to 255 characters. To
move to the next line, use the <CR>. To send the message use CTR-Z, to abort a message use CTR-C.
rpm slot number
Enter the slot number
E1200i: 0-13
E600i: 0-6
on |off
Toggles the LED on the RPM on or off.
Version 8.2.1.0 Introduced on the E-Series ExaScale
* Enter the asterisk character * to send a message to all tty lines.
line
Send a message to a specific line.
Range: 0 to 11
aux Enter the keyword aux to send a message to an Auxiliary line.
Note: This option is supported on E-Series only.
console Enter the keyword console to send a message to the Primary terminal line.
vty Enter the keyword vty to send a message to the Virtual terminal
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.5.1.0 Introduced on E-Series