Installation Manual

Installing S25N and S25V Systems 5
This guide provides site preparation recommendations, step-by-step procedures for rack mounting and
desk mounting, inserting optional modules, and connecting to a power source.
After you have completed the hardware installation and power-up of the system, refer to the FTOS
Configuration Guide for the S-Series for software configuration information and the FTOS Command
Reference for the S-Series for detailed Command Line Interface (CLI) information, as detailed in Related
Publications, below.
Information Symbols and Warnings
The following graphic symbols are used in this document to bring attention to hazards that exist when
handling the system and its components. Please read these alerts and heed their warnings and cautions.
Table 1 describes symbols contained in this guide.
Preface About this Guide
Table 1 Information Symbols
Symbol Warning Description
Danger
This symbol warns that improper handling and installation could result in bodily injury.
Before you begin work on this equipment, be aware of hazards involving electrical
circuitry, networking environments, and instigate accident prevention procedures.
Caution
This symbol informs you that improper handling and installation could result in equipment
damage or loss of data.
Warning
This symbol informs you that improper handling may reduce your component or system
performance.
Note This symbol informs you of important operational information.
Danger: The installation of this equipment shall be performed by trained and qualified personnel only.
Read this guide before installing and powering up this equipment. This equipment contains two power
cords. Disconnect both power cords before servicing.