Configuration manual

PIM Sparse-Mode | 775
Figure 35-2. Viewing PIM Neighbors Command Example
Display the PIM routing table using the command show [ip | ipv6] pim tib from EXEC privilege mode, as
shown in Figure 35-3.
Figure 35-3. Viewing the PIM Multicast Routing Table
Configurable S,G Expiry Timers
By default S, G entries expire in 210 seconds. You can configure a global expiry time (for all (S,G) entries)
or configure a expiry time for a particular entry. If both are configured, the ACL supercedes the global
configuration for the specified entries.
When an expiry time created, deleted, or updated, the changes are applied when the keep alive timer
refreshes.
To configure a global expiry time:
Task Command Command Mode
Enable global expiry timer for S, G entries
Range 211-86400 seconds
Default: 210
ip pim sparse-mode
sg-expiry-timer
seconds
CONFIGURATION
Force10#show ip pim neighbor
Neighbor Interface Uptime/Expires Ver DR
Address Prio/Mode
127.87.5.5 Gi 4/11 01:44:59/00:01:16 v2 1 / S
127.87.3.5 Gi 4/12 01:45:00/00:01:16 v2 1 / DR
127.87.50.5 Gi 7/13 00:03:08/00:01:37 v2 1 / S
Force10#
Force10#show ip pim tib
PIM Multicast Routing Table
Flags: D - Dense, S - Sparse, C - Connected, L - Local, P - Pruned,
R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT,
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode
(*, 192.1.2.1), uptime 00:29:36, expires 00:03:26, RP 10.87.2.6, flags: SCJ
Incoming interface: GigabitEthernet 4/12, RPF neighbor 10.87.3.5
Outgoing interface list:
GigabitEthernet 4/11
GigabitEthernet 7/13
(10.87.31.5, 192.1.2.1), uptime 00:01:24, expires 00:02:26, flags: FT
Incoming interface: GigabitEthernet 7/11, RPF neighbor 0.0.0.0
Outgoing interface list:
GigabitEthernet 4/11
GigabitEthernet 4/12
GigabitEthernet 7/13
--More--