Configuration manual

Configuration Fundamentals | 41
Figure 2-3 illustrates how to change the command mode from CONFIGURATION mode to PROTOCOL
SPANNING TREE.
Figure 2-3. Changing CLI Modes
MAC ACCESS-LIST
STANDARD ACCESS-
LIST
Force10(config-std-macl)# mac access-list standard
EXTENDED ACCESS-
LIST
Force10(config-ext-macl)# mac access-list extended
MULTIPLE
SPANNING TREE
Force10(config-mstp)#
protocol spanning-tree mstp
Per-VLAN SPANNING
TREE Plus
Force10(config-pvst)#
protocol spanning-tree pvst
PREFIX-LIST Force10(conf-nprefixl)# ip prefix-list
RAPID SPANNING
TREE
Force10(config-rstp)#
protocol spanning-tree rstp
REDIRECT Force10(conf-redirect-list)# ip redirect-list
ROUTE-MAP Force10(config-route-map)# route-map
ROUTER BGP Force10(conf-router_bgp)# router bgp
ROUTER ISIS Force10(conf-router_isis)# router isis
ROUTER OSPF Force10(conf-router_ospf)# router ospf
ROUTER RIP
Force10(conf-router_rip)#
router rip
SPANNING TREE Force10(config-span)# protocol spanning-tree 0
TRACE-LIST Force10(conf-trace-acl)# ip trace-list
Table 2-1. FTOS Command Modes
CLI Command Mode Prompt
Access Command
Force10(conf)#protocol spanning-tree 0
Force10(config-span)#
New command prompt