Configuration manual

312 | Content Addressable Memory for ExaScale
www.dell.com | support.dell.com
Create new CAM-profile
FTOS supports creating individual CAM-profiles, but Dell Force10 does not certify that these templates
will function as expected. Follow these steps to create a new CAM-profile.
Figure 12-4. Create and Validate a new CAM-profile template
Step Task Command Syntax Command Mode
1
Define a CAM-profile template. cam-profile template [10M-CAM]
template is a 16 character string used as a
template name
CONFIGURATION
Note: Enter 10M-CAM to specify the 10M CAM line card. Otherwise, the system defaults to the 40M
CAM line card settings.
2 Configure the CAM/SRAM regions. Layer 2 : layer-2 eg-acl {value} fib {value} frrp
{value} ing-acl {value} learn {value} l2pt
{value} qos {value} system-flow {value}
Layer 3: layer-3 [ipv4 | ipv6] eg-acl {value} fib
{value} ing-acl {value}
Flow: flow [ipv4 | ipv6] multicast-fib {value}
pbr {value} qos {value} system-flow {value}
CONFIGURATION-C
AM-profile
Note: You do not need to enter every parameter for a region. You
can enter only the ones you need.
Note: User configured CAM-profiles are automatically validated
(Figure 12-4).
3 Enable the CAM-profile template.
enable
When you enable a template, you are prompted
to save the running-configuration and reload the
system (Figure 12-4).
CONFIGURATION-C
AM-profile
Force10(conf-cam-prof-Customer 001)#flow ipv4 multicast-fib 10 pbr 20 qos 25 system-flow 3
Force10(conf-cam-prof-Customer 001)#enable
CAM profile '10M-L2-Switched' is currently enabled.
Do you want to disable it and continue? [yes/no]: y
Updating the cam-profile will need a chassis reboot.
System configuration has been modified. Save? [yes/no]: y
Proceed with reload [confirm yes/no]: n
Force10(conf)#cam-profile Customer001
Force10(conf-cam-prof-Customer001)#flow ipv4 multicast-fib 10 pbr 20 qos 25 system-flow 30
!
% Error: cam-profile validation fail
Force10(conf-cam-prof-Customer 001)#