Configuration manual

Content Addressable Memory for ExaScale | 311
Select a pre-defined (Dell Force10 recommended) CAM-profile template.
Figure 12-3. Enable CAM-profile template
Step Task Command Syntax Command Mode
1
Select a CAM-profile template. cam-profile template [10M-CAM]
template is the name of a pre-defined Dell
Force10 CAM-profile template:10M-L2,
10M-L2-IPv6-Switching, 40M-L2-IPv6-IPv4,
40M-L2-IPv4Only, VRF, MAX-IPv4-FIB
CONFIGURATION
Note: Enter 10M-CAM to specify the 10M CAM line card. Otherwise, the system defaults to the 40M
CAM line card settings.
2 Configure the regions as defined
for the template in Table 12-3.
<regions and values>
The Regions :
Layer 2 : layer-2 eg-acl {value} fib {value} frrp
{value} ing-acl {value} learn {value} l2pt
{value} qos {value} system-flow {value}
Layer 3: layer-3 [ipv4 | ipv6] eg-acl {value} fib
{value} ing-acl {value}
Flow: flow [ipv4 | ipv6] multicast-fib {value}
pbr {value} qos {value} system-flow {value}
CONFIGURATION-
CAM-profile-template
3 Enable the CAM-profile template.
enable
When you enable a template, you are prompted
to save the running-configuration and reload the
system (Figure 12-4).
CONFIGURATION-
CAM-profile-template
Note: The message above does not appear if the default CAM-profile is enabled when you try to enable a
new CAM-profile. The validation message appears when changing from a non-default CAM-profile to
another non-default CAM-profile.
Force10(conf-cam-prof-10M-L2)#enable
Updating the cam-profile will need a chassis reboot.
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
Force10(conf-cam-prof-10M-L2)#