Configuration manual

E-Series ExaScale Debugging and Diagnostics | 1255
• Display the replication configuration for RPIs. This is used to troubleshoot why multicast streams are
not reaching all receivers.
show hardware linecard {0-13} port-set {0-1 | all} btm {ingress | egress | all} replication-config
• Display up to 32 WRED high/low threshold registers and WRED curve registers.
show hardware linecard {0-13} port-set {0-1 | all} btm {ingress | egress | all} wred-config
• Display the rate police/limiting configurations; use formula in 1.1.5.6 Rate Calculation. Use this
command to confirm that rate limiting has been activated and drops are occurring.
show hardware linecard {0-13} port-set {0-1 | all} btm {ingress | egress | all} ratelimiting
FPC CLIs
• Display FPC-I and FPC-E counters and status registers.
show hardware linecard {0-13} port-set {0-1 | all} fpc forward {config | detailed} –
•
config is useful to troubleshoot tap-delay issues
•
detailed summarizes specific index commands
• Display FPC-L counters and status registers.
show hardware linecard {0-13} port-set {0-1 | all} fpc lookup
Lookup Table Index Ranges
Layer2 IPv4 IPv6
local-da start-index [number-of-entries]
[raw]
ipv4-flow start-index
[number-of-entries] [raw]
ipv6-fib start-index
[number-of-entries] [raw]
l2-fib start-index [number-of-entries] [raw] ipv4-fib start-index
[number-of-entries] [raw]
ipv6-nh start-index
[number-of-entries] [raw |
nh-format]
l2-acl-ingress start-index
[number-of-entries] [raw]
ipv4-nh start-index
[number-of-entries] [raw |
nhop-format]
ipv6-flow start-index
[number-of-entries] [raw]
l2-acl-egress start-index
[number-of-entries] [raw
ipv4-acl-ingress start-index
[number-of-entries] [raw]
ipv6-acl-ingress start-index
[number-of-entries] [raw]
ipv4-acl-egress start-index
[number-of-entries] [raw]
ipv6-acl-egress start-index
[number-of-entries] [raw]
epi start-index [number-of-entries]
[raw]