Quick Start Manual

18 Installing the Software
NOTE: Creating a management IP address is supported by both the Layer 2
(Switching) and Layer 3 (Routing) licenses of SFTOS.
By default, the management address is reachable from all ports on the default
VLAN, VLAN 1. One or more ports in that VLAN must be enabled.
After you enable and connect ports in the management VLAN and configure the
management IP address, you can manage the switch through a variety of means.
Configure a Username and Password
The username passwd command creates the username and password in one
statement. You can change a password either by reentering the command with
the new password or by removing the user with the no username command and
reentering the user with a new password.
Configure the Enable Password
The Privileged Exec password (commonly called the “enable” password), is not
set when the S2410 starts for the first time. To set the enable password, access
the Privileged Exec mode (also called “enable mode”) and then the Global
Config mode. Enter the enable passwd command, then press Enter.
3 Invoke the (Config-if-ma)#
prompt.
interface
managementethernet
Global Config
4 Set the IP address and subnet
mask of the management
interface.
ip address ipaddr
subnetmask
(Config-if-ma)#
prompt within the
Global Config
mode
Step Task Command Syntax Command Mode
1 Configure a username and
password.
username passwd Config
2 Removing a username. no username Config
Step Task Command Syntax Command Mode