Quick Reference Guide

98 | System Configuration Commands
www.dell.com | support.dell.com
no monitor session 1
This command removes all the source ports and a destination port of the mirroring session and restore
the default value for mirroring session mode.
The 1 or session-id parameter is an integer value used to identify the session. In the current version of
the software, the
session-id parameter is always 1.
This is a stand-alone “no” command. This command does not have a “normal” form. This command
can be issued without regard for the session status (enabled or disabled).
Syntax
no monitor session 1
Default
enabled
Mode
Global Config
rate-interval
This command sets the traffic monitoring rate interval in seconds.
Syntax
rate-interval 15-300
Default
299 seconds
Mode
Interface Config; Interface Port Channel Config; Interface Range Ethernet; Interface Range Port
Channel
Command
History
show forwardingdb agetime
This command displays the timeout for address aging. In an SVL system, the [fdbid | all] parameter is
not used and will be ignored if entered.
Syntax
show forwardingdb agetime
Mode
Privileged Exec
Example
Figure 6-31. Example of show forwardingdb agetime Command Output
Command
History
Version 2.5.1 Introduced
Force10 #show forwardingdb agetime
Address Aging Timeout:300
Force10#
Version 2.3 Modified: Removed parameters and statements relating to IVL.