Quick Reference Guide

94 | System Configuration Commands
www.dell.com | support.dell.com
Figure 6-29. Commands Available in Interface Range Mode
Figure 6-30. Multiple Ranges Selected for Configuration for Physical Ports
Note in Figure 6-30 that port ranges in separate stack members have been selected.
For more on VLAN commands, see VLAN Commands on page 125.
For more on LAG commands, see LAG/Port Channel Commands on page 287.
For more on bulk configuration, see the Bulk Configuration section in the Interfaces chapter of the
SFTOS Configuration Guide.
(s50-1) (conf-if-range-et-1/0/10-1/0/22)#?
addport Add this port to a port-channel.
auto-negotiate Enables/Disables automatic negotiation on a port.
classofservice Configure Class of Service parameters.
cos-queue Configure the Cos Queue Parameters.
deleteport Delete this port from a port-channel.
description Add Description to the interface
dot1x Configure Dot1x interface commands.
exit To exit from the mode.
gmrp Set GARP Multicast Registration Protocol parameters.
gvrp Set GARP VLAN Registration Protocol parameters.
igmp Enable/Disable IGMP Snooping on a selected interface
ip Configure IP parameters.
mac Configure MAC Access List group parameters.
mode Configure the double VLAN tunnel mode for this interface.
mtu Sets the default MTU size.
port Configure a physical port.
port-channel Enable/Disable the port-channel's administrative mode.
port-security Enable/Disable Port MAC Locking/Security for interface.
protocol Configure the Protocol Based VLAN parameters.
service-policy Configure DiffServ Service.
set Configure switch options and settings.
shutdown Enable/Disable a port.
snmp Configure SNMP options.
snmp-server Enable/Disable SNMP violation traps interface.
spanning-tree Set the spanning tree operational mode.
speed Sets the speed and duplex setting for the interface.
traffic-shape Configure the maximum transmission bandwidth limit.
vlan Configure VLAN parameters.
(s50-1) (conf-if-range-et-1/0/10-1/0/22)#ip ?
access-group Add Access List to the Group.
address Create an IP Address and subnet for an interface.
dvmrp Configure DVMRP parameters.
igmp Configure IGMP parameters.
igmp-proxy Configure IGMP Proxy parameters.
irdp Enables Router Discovery on an interface. Use no
command to disable.
multicast Configure multicast routing parameters.
netdirbcast Enables net directed broadcasts. Use no command to
disable.
ospf Configure Open Shortest Path First parameters.
pimdm Configure PIM-DM parameters.
pimsm Configure PIM-SM parameters.
proxy-arp Enables or disables Proxy ARP on an interface.
rip Configure Router Interface Protocol settings in the
router.
vrrp Configure Virtual Router Redundancy Protocol
parameters.
(s50-1) (conf-if-range-et-1/0/10-1/0/21)#mode ?
dvlan-tunnel Configure double VLAN tunneling for a specific port.
dot1q-tunnel Configure double VLAN tunneling for a specific port.
(s50-1) (conf-if-range-et-1/0/10-1/0/21)#vlan ?
priority Configure the priority for untagged frames.
Force10(config)#interface range ethernet 5/0/1-5/0/23,1/0/49-1/0/50,2/0/10-2/0/12
Force10(config-if-range)#no shutdown
Force10(config-if-range)#