Quick Reference Guide

System Configuration Commands | 93
The VLAN Range mode commands appear in Figure 6-27.
Figure 6-27. Commands Available in VLAN Range Mode
The Port Channel Range mode commands (LAG commands) appear in Figure 6-28.
Figure 6-28. Commands Available in Port Channel Range Mode
The command families available from the Ethernet Range prompt (for configuring all physical ports)
are displayed in Figure 6-29.
(s50-1) (conf-if-range-vl-10,20)#?
encapsulation Configure interface link layer encapsulation type.
exit To exit from the mode.
igmp Configure IGMP Snooping parameters for the Vlan
ip Configure IP parameters.
makestatic Change the VLAN type from 'Dynamic' to 'Static'.
mtu Sets the default MTU size.
name Configure an optional VLAN Name.
protocol Configure the Protocols associated with particular
Group Ids.
shutdown Enable/Disable a port.
tagged Configure tagging for a specific VLAN port.
(s50-1)(Config)#interface range port-channel 1,3
(s50-1)(conf-if-range-po-1,3)#?
classofservice Configure Class of Service parameters.
cos-queue Configure the Cos Queue Parameters.
description Add Description to the interface
dot1p-priority Configure the priority for untagged frames.
exit To exit from the mode.
gmrp Set GARP Multicast Registration Protocol parameters.
gvrp Set GARP VLAN Registration Protocol parameters.
igmp Enable/Disable IGMP Snooping on a selected interface
ip Configure IP parameters.
mac Configure MAC Access List group parameters.
mode Configure the double VLAN tunnel mode for this
interface.
mtu Sets the default MTU size.
port-security Enable/Disable Port MAC Locking/Security for
interface.
protocol Configure protocol type for port-channel.
rate-interval Sets the traffic monitoring rate interval
service-policy Configure DiffServ Service.
set Configure switch options and settings.
shutdown Enable/Disable a port.
snmp Configure SNMP options.
snmp-server Enable/Disable SNMP violation traps interface.
spanning-tree Set the spanning tree operational mode.
vlan Configure VLAN parameters.