Quick Reference Guide

88 | System Configuration Commands
www.dell.com | support.dell.com
• rate-interval on page 98
• show forwardingdb agetime on page 98
• show interface loopback on page 99
• show mac-address-table on page 99
• show mac-address-table multicast on page 100
• show mac-address-table stats on page 100
• show monitor session on page 101
• show port on page 101
• show port protocol on page 103
• shutdown (port) on page 103
• shutdown all (port) on page 103
• speed on page 104
• speed all on page 104
MAC Database
Commands
Among the commands in this section are the following four commands that you use to configure and
view information about the MAC address database:
• bridge aging-time on page 89
• show forwardingdb agetime on page 98
• show mac-address-table multicast on page 100
• show mac-address-table stats on page 100
cablestatus
This command tests the status of the cable attached to an interface.
Syntax
O rgEnC CWnu<unit/slot/port>
Mode
Privileged EXEC
auto-negotiate
This command enables automatic speed negotiation on a port.
Syntax
[oe] WCe6oE:eCa CE
The default value is enable.
Note: Broadcast storm control commands are in the ACL chapter, in the section Broadcast
Storm Control Commands on page 389.
Interface routing commands are in the section IP Routing on page 397 in Chapter 22,
Routing Commands.
Note: Automatic sensing is disabled when automatic negotiation is disabled.