Quick Reference Guide

System Configuration Commands | 87
6
System Configuration Commands
This chapter provides a detailed explanation of the system configuration commands in the following
major sections:
• System Configuration Commands on page 87
• System Utility Commands on page 105
• PoE Commands on page 114
• Dual Image Management Commands on page 119
• Configuration Scripting on page 122
System Configuration Commands
This section describes the following system configuration commands:
• auto-negotiate on page 88
• auto-negotiate all on page 89
• bridge aging-time on page 89
• configure on page 90
• enable on page 90
• interface on page 91
• interface range on page 91
• interface loopback on page 95
• monitor session on page 95
• monitor session 1 mode on page 96
• mtu (port) on page 97
• no monitor on page 97
• no monitor session 1 on page 98
Note:
See also Chapter 5, “System Management Commands,” on page 35 and Chapter 9,
“System Logs,” on page 169.
For VLAN commands, see the chapter LAG/Port Channel Commands on page 287.
For port channel (LAG) commands, see the chapter LAG/Port Channel Commands
on page 287.
For port security commands, also known as port MAC locking, see the section Port
Security Commands on page 183 in the chapter Security Commands on page 183