Quick Reference Guide

82 | System Management Commands
www.dell.com | support.dell.com
Mode
Global Config
Command
History
snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link traps are sent
only if the Link Trap flag setting associated with the port is enabled (see ‘snmp trap link-status’
command).
Syntax
[no] snmp-server enable traps linkmode
The no version of this command disables Link Up/Down traps for the entire switch.
Default
enabled
Mode
Global Config
snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is sent
when a user logs in to the terminal interface (EIA 232 or telnet) and there is an existing terminal
interface session.
Syntax
[no] snmp-server enable traps multiusers
The no version of this command disables Multiple User traps.
Default
enabled
Mode
Global Config
snmp-server enable traps stpmode
This command enables the sending of new root traps and topology change notification traps.
Syntax
[no] snmp-server enable traps stpmode
The no version of this command disables the sending of new root traps and topology change
notification traps.
Default
enabled
Mode
Global Config
Version 2.3 Introduced
Note: The CLI indicates successful execution of this command, and the show trapflags report
shows successful execution of the command, but this trap is not currently supported.