Quick Reference Guide

System Management Commands | 77
SNMP Management Commands
This section describes the SNMP system management commands supported by SFTOS:
• show snmpcommunity on page 78
• show snmptrap on page 78
• show trapflags on page 79
• snmp-server on page 79
• snmp-server community on page 80
• snmp-server community ipaddr on page 80
• snmp-server community ipmask on page 80
• snmp-server community mode on page 81
• snmp-server community ro on page 81
• snmp-server community rw on page 81
• snmp-server enable traps bcaststorm on page 81
• snmp-server enable traps linkmode on page 82
• snmp-server enable traps multiusers on page 82
• snmp-server enable traps stpmode on page 82
• snmp-server enable trap violation on page 83
• snmp-server traps enable on page 83
• snmptrap on page 83
• snmptrap ipaddr on page 84
• snmptrap mode on page 84
• snmp trap link-status (interface) on page 84
• snmp trap link-status all on page 85
• snmptrap snmpversion on page 85
For information on configuring SNMP, see the Management chapter in the SFTOS Configuration
Guide.
Stop Bits The number of stop bits per character. The number of stop
bits is always 1.
Parity The parity method used on the serial port. The parity method
is always None.
Table 5-13. Fields of show serial Command Output (continued)
Field Description
Note: The Layer 3 Routing Package of SFTOS also contains these SNMP traps:
In Global Config mode:
•[no] ip dvmrp trapflags: Sets the DVMRP (Distance Vector Multicast Routing Protocol) traps
flag (disabled by default). See the Multicast chapter.
•[
no] ip pim-trapflags: Sets the PIM traps flag (disabled by default). See the PIM chapter.
In Router OSPF Config mode:
•[no] trapflags: Sets the OSPF traps flag. See the OSPF chapter (enabled by default).