Quick Reference Guide

70 | System Management Commands
www.dell.com | support.dell.com
Related
Commands
vlan participation (management VLAN only)
This command assigns the management VLAN of the switch.
Syntax
[no] vlan participation vlan_id
The value for vlan_id is the VLAN that you want to use for the management interface (By default,
VLAN 1 is used.)
Mode
Interface ManagementEthernet. Uses the (Config-if-ma)# prompt, accessed by interface
managementethernet.
Default
VLAN 1 (default management VLAN; all enabled ports are on VLAN 1 by default, so all ports are
capable, by default, of being management ports.)
Command
History
Related
Commands
Software Version The release.version.revision number of the code currently
running on the switch
Additional Packages This displays the additional packages that are incorporated into
this system, such as Dell Force10 Multicast.
10/100 Ethernet/802.3 interface(s) Copper ports running at 10/100 speed reporting link UP
Gig Ethernet/802.3 interface(s) Copper/fiber ports running at 1Gb speed reporting link UP
10Gig Ethernet/802.3 interface(s) 10Gb optional module
Virtual Ethernet/802.3 interface(s) Layer 3 VLAN interfaces
System Name
System Location
System Contact
System Object ID
System Up Time
Table 5-12. Fields in Output of show version Command (continued)
Headings Explanation
show hardware Inventory information for the switch
show sysinfo Switch information, including list of supported MIBs
show tech-support
Displays the output of many
show commands, including this one.
Version 2.3
Introduced: Replaces the command
network mgmt_vlan on page 131.
management route default Sets the IP gateway of the switch.
interface managementethernet Invokes the Interface ManagementEthernet mode, the
(Config-if-ma)# prompt.