Quick Reference Guide

58 | System Management Commands
www.dell.com | support.dell.com
Related
Commands
Java Mode Enable or Disable. Specifies if the switch should allow access to the Java
applet in the header frame. Enabled means the applet can be viewed. The
factory default is disabled.
Locally Administered MAC
Address
If desired, a locally administered MAC address can be configured for
in-band connectivity. To take effect, 'MAC Address Type' must be set to
'Locally Administered'. Enter the address as twelve hexadecimal digits (6
bytes) with a colon between each byte. Bit 1 of byte 0 must be set to a 1 and
bit 0 to a 0, i.e. byte 0 should have the following mask 'xxxx xx10'. The
MAC address used by this bridge when it must be referred to in a unique
fashion. It is recommended that this be the numerically smallest MAC
address of all ports that belong to this bridge. However it is only required to
be unique. When concatenated with dot1dStpPriority a unique
BridgeIdentifier is formed which is used in the Spanning Tree Protocol.
MAC Address Type Specifies which MAC address should be used for in-band connectivity. The
choices are the burned in or the Locally Administered address. The factory
default is to use the burned in MAC address.
Management VLAN ID Specifies the management VLAN ID.
Network Configuration Protocol
Current
Indicates which network protocol is being used. The options are bootp |
dhcp | none.
Web Mode Enable or Disable
Table 5-9. Fields in Output of show interface managementethernet command
Field Description
ip address (management) Configures the IP address of the management interface.
show ethernet Displays statistics for a specific port or for the switch.
show interface Displays statistics for a specific port.
show interface switchport Displays a summary of statistics on Layer 2 interfaces.
show interface ethernet Displays detailed statistics for a specific ethernet port or for all CPU traffic
based upon the argument.
show interfaces Displays information about a selected interface or VLAN