Quick Reference Guide

492 | PIM Commands
www.dell.com | support.dell.com
ip pimsm query-interval
This command configures the transmission frequency of hello messages in seconds between PIM
enabled neighbors. This field has a range of 10 to 3600 seconds.
Syntax
ip pimsm query-interval 10-3600
The no ip pimsm query-interval command resets the transmission frequency of hello messages
between PIM enabled neighbors to the default value.
Default
30
Mode
Interface Config or Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
ip pimsm spt-threshold
This command is used to configure the Threshold rate for the RP router to switch to the shortest path.
The rate is specified in Kilobytes per second. The possible values are 0 to 2000.
Syntax
ip pimsm spt-threshold 0-2000
The no ip pimsm spt-threshold command is used to reset the Threshold rate for the RP router to
switch to the shortest path to the default value.
Default
50
Mode
Global Config
ip pim-trapflags
This command enables the PIM trap mode for both Sparse Mode (SM) and Dense Mode. (DM).
Syntax
[no] ip pim-trapflags
The no version of this command disables the PIM trap mode.
Default
disabled
Mode
Global Config
Usage
Information
Use this command in conjunction with other SNMP management commands, described in SNMP
Management Commands on page 77.
Version 2.3 Added Interface Range and Interface VLAN modes.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.