Quick Reference Guide

System Management Commands | 49
Figure 5-11. S50V: Output of the show interface unit/slot/port Command
When the show interface unit/slot/port command is run on the S50V, the following second
group of fields is also displayed (these fields are displayed by the show interface ethernet
unit/slot/port command.):
Related
Commands
Table 5-6. Fields in Output of show interface unit/slot/port Command
Field Description
Packets Received Without Error The total number of packets (including broadcast packets and multicast
packets) received on the interface.
Packets Received With Error The number of inbound packets that contained errors preventing them
from being deliverable to a higher-layer protocol.
Broadcast Packets Received The total number of packets received that were directed to the broadcast
address. Note that this does not include multicast packets.
Packets Transmitted Without Error The total number of packets transmitted out of the interface.
Transmit Packet Errors The number of outbound packets that could not be transmitted because
of errors.
Collision Frames The number of packet collisions
Time Since Counters Last Cleared The elapsed time, in days, hours, minutes, and seconds since the
statistics for this switch were last cleared.
Force10-S50V#show interface 1/0/1
Packets Received Without Error................. 1555
Packets Received With Error.................... 0
Broadcast Packets Received..................... 642
Packets Transmitted Without Errors............. 0
Transmit Packet Errors......................... 0
Collision Frames............................... 0
Time Since Counters Last Cleared............... 3 day 20 hr 59 min 6 sec
Native Vlan.................................... 1
Rate Info (interval 300 seconds):
Packets Rx Rate Mbits/sec...................... 00.00
Packets Tx Rate Mbits/sec...................... 00.00
Packets Rx Rate packets/sec.................... 00.00
Packets Tx Rate packets/sec.................... 00.00
Packets Rx Line Rate........................... 0.00%
Packets Tx Line Rate........................... 0.00%
Force10-S50V#
ip address (management) Configures the IP address of the management interface.
show ethernet Displays detailed statistics for a specific port or summary information for all
CPU traffic, based upon the argument.
show interface ethernet Displays detailed statistics for a specific port or for all CPU traffic based
upon the argument.
show interface switchport Displays a summary of statistics on Layer 2 interfaces.