Quick Reference Guide

486 | PIM Commands
www.dell.com | support.dell.com
ip pimdm mode
This command sets administrative mode of PIM-DM on an interface to enabled.
Syntax
[no] aduda,.,u,e.E unit/slot/port
The no version of this command sets administrative mode of PIM-DM on an interface to disabled.
Default
disabled
Mode
Interface Config or Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
ip pimdm query-interval
This command configures the transmission frequency of hello messages between PIM enabled
neighbors. This field has a range of 10 to 3600 seconds.
Syntax
ip pimdm query-interval seconds
no ip pimdm query-interval
The no version of this command resets the transmission frequency of hello messages between PIM
enabled neighbors to the default value.
Default
30
Mode
Interface Config or Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
show ip pimdm
This command displays the system-wide information for PIM-DM.
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Unsupported: not tested in 2.5.1
Version 2.3 Added Interface Range and Interface VLAN modes.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Unsupported: not tested in 2.5.1
Version 2.3 Added Interface Range and Interface VLAN modes.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.