Quick Reference Guide

PIM Commands | 485

PIM Commands

This chapter contains the following major sections:

• PIM-DM Commands on page 485

• PIM-SM Commands on page 488

PIM-DM Commands

This section provides Protocol Independent Multicast–Dense Mode (PIM-DM) command syntax. The

commands are:

• ip pimdm on page 485

• ip pimdm mode on page 486

• ip pimdm query-interval on page 486

• show ip pimdm on page 486

• show ip pimdm interface on page 487

• show ip pimdm interface stats on page 487

• show ip pimdm neighbor on page 488

ip pimdm

This command enables the administrative mode of PIM-DM in the router.

Syntax

[oe] aduda,.,

The oe version of this command disables the administrative mode of PIM-DM in the router. IGMP

must be enabled before PIM-DM can be enabled.

Default

disabled

Mode

Global Config

Command

History

Note: The PIM-DM feature was available in SFTOS before version 2.5.1, but the commands

were not tested in either 2.5.1 or 2.5.2, so the commands in this section are not supported.

Version 2.5.2 Unsupported: not tested in 2.5.2

Version 2.5.1 Unsupported: not tested in 2.5.1