Quick Reference Guide

IP Multicast Commands | 467
Command
History
ip dvmrp metric
This command configures the value used in DVMRP messages as the cost to reach this network or
selected VLAN.
Syntax
ip dvmrp metric value
The value field has a range of 1 to 63 for a selected interface, 1 to 31 for the selected VLAN.
The no version of this command resets the metric for an interface to the default value. This value is
used in the DVMRP messages as the cost to reach this network.
Default
1
Mode
Interface Config or Interface VLAN
Command
History
ip dvmrp trapflags
This command enables the DVMRP trap mode.
The no version of this command disables the DVMRP trap mode.
Syntax
[no] ip dvmrp trapflags
Default
disabled
Mode
Global Config
Command
History
Usage
Information
Use this command in conjunction with other SNMP management commands, described in SNMP
Management Commands on page 77.
show ip dvmrp
This command displays the system-wide information for DVMRP.
Syntax
show ip dvmrp
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Unsupported: not tested in 2.5.1
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Unsupported: not tested in 2.5.1
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Unsupported: not tested in 2.5.1