Quick Reference Guide

466 | IP Multicast Commands
www.dell.com | support.dell.com
• Configuration commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.
This section contains the following commands:
• ip dvmrp (global) on page 466
• ip dvmrp (interface) on page 466
• ip dvmrp metric on page 467
• ip dvmrp trapflags on page 467
• show ip dvmrp on page 467
• show ip dvmrp interface on page 468
• show ip dvmrp neighbor on page 468
• show ip dvmrp nexthop on page 469
• show ip dvmrp prune on page 470
• show ip dvmrp route on page 470
ip dvmrp (global)
This command sets administrative mode of DVMRP in the router to active. IGMP must be enabled
before DVMRP can be enabled.
Syntax
[no] ip dvmrp
The no version of this command sets the administrative mode of DVMRP in the router to inactive.
IGMP must be enabled before DVMRP can be enabled.
Default
disabled
Mode
Global Config
Command
History
ip dvmrp (interface)
This command sets administrative mode of DVMRP on an interface to active.
Syntax
[no] ip dvmrp
The no version of this command sets administrative mode of DVMRP on an interface to inactive.
Default
disabled
Mode
Interface Config
Note: The DVMRP feature was available in SFTOS before version 2.5.1, but the commands
were not tested in either 2.5.1 or 2.5.2, so the commands in this section are not supported.
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Unsupported: not tested in 2.5.1