Quick Reference Guide

450 | RIP Commands
www.dell.com | support.dell.com
default-information originate (RIP)
This command is used to control the advertisement of default routes.
The no version of this command is used to control the advertisement of default routes.
Syntax
[no] default-information originate
Mode
Router RIP Config
default-metric (RIP)
This command is used to set a default for the metric of distributed routes.
The no version of this command is used to reset the default metric of distributed routes to its default
value.
Syntax
default-metric <0-15>
no default-metric
Mode
Router RIP Config
distance rip
This command sets the route preference value of RIP in the router. Lower route preference values are
preferred when determining the best route.
The no version of this command sets the default route preference value of RIP in the router.
Syntax
distance rip <0-255>
no distance rip
Default
15
Mode
Router RIP Config
distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
The no version of this command is used to specify the access list to filter routes received from the
source protocol.
Syntax
[no]udistribute-list <1-199> out {ospf | static | connected}