Quick Reference Guide

RIP Commands | 449

RIP Commands

This chapter provides a detailed explanation of the Routing Information Protocol (RIP) commands.

The commands are divided by functionality into the following different groups:

• Show commands are used to display switch settings, statistics and other information.

• Configuration Commands are used to configure features and options of the switch. For every

configuration command there is a show command that will display the configuration setting.

This chapter provides details on the following commands:

• auto-summary on page 449

• default-information originate (RIP) on page 450

• default-metric (RIP) on page 450

• distance rip on page 450

• distribute-list out on page 450

• enable (RIP) on page 451

• ip rip on page 451

• ip rip authentication on page 451

• ip rip receive version on page 452

• ip rip send version on page 452

• hostroutesaccept on page 453

• split-horizon on page 453

• redistribute on page 453

• show ip rip on page 454

• show ip rip interface brief on page 455

• show ip rip interface on page 455

auto-summary

This command enables the RIP auto-summarization mode.

Syntax

[oe] WCe6nW,, sI

The oe version of this command disables the RIP auto-summarization mode.

Default

enabled

Mode

Router RIP Config