Quick Reference Guide

OSPF Commands | 447
Advertisement—The status of the advertisement. Advertisement has two possible settings: enabled or
disabled.
show ip ospf stub table
This command displays the OSPF stub table. The information below will only be displayed if OSPF is
initialized on the switch.
Syntax
show ip ospf stub table
Mode
Privileged Exec and User Exec
Report Fields
Area ID—Is a 32-bit identifier for the created stub area.
Type of Service—Is the type of service associated with the stub metric. SFTOS only supports Normal
TOS.
Metric Val—The metric value is applied based on the TOS. It defaults to the least metric of the type of
service among the interfaces to other areas. The OSPF cost for a route is a function of the metric value.
Metric Type—Is the type of metric advertised as the default route.
Import Summary LSA—Controls the import of summary LSAs into stub areas.
show ip ospf virtual-link
This command displays the OSPF Virtual Interface information for a specific area and neighbor. The
areaid parameter identifies the area and the neighbor parameter identifies the neighbor's Router ID.
Syntax
show ip ospf virtual-link areaid neighbor
Mode
Privileged Exec and User Exec
Report Fields
Area ID—The area ID of the requested OSPF area.
Neighbor Router ID—The input neighbor Router ID.
Hello Interval—The configured hello interval for the OSPF virtual interface.
Dead Interval—The configured dead interval for the OSPF virtual interface.
Iftransit Delay Interval—The configured transit delay for the OSPF virtual interface.
Retransmit Interval—The configured retransmit interval for the OSPF virtual interface.
Authentication Type—The configured authentication type of the OSPF virtual interface.
State—The OSPF Interface States are: down, loopback, waiting, point-to-point, designated router, and
backup designated router. This is the state of the OSPF interface.
Neighbor State—The neighbor state.