Quick Reference Guide

OSPF Commands | 437
Syntax
ip ospf retransmit-intervalrseconds
The value for seconds is the number of seconds between link-state advertisement retransmissions for
adjacencies belonging to this router interface. This value is also used when retransmitting database and
link-state request packets.
Range: 0 to 3600 seconds (1 hour)
The no ip ospf retransmit-interval command sets the OSPF retransmit interval for the specified
interface to the default.
Default
5 (seconds)
Mode
Interface Config; Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
ip ospf transmit-delay
This command sets the OSPF transit delay for the specified interface.
Syntax
ip ospf transmit-delay seconds
The transmit delay is specified in seconds. In addition, it sets the estimated number of seconds it takes
to transmit a link state update packet over this interface.
Range: 1 to 3600 (1 hour)
The no ip ospf transmit-delay command sets the OSPF Transit Delay for the specified interface to
the default.
Default
1
Mode
Interface Config; Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
Version 2.3 Added Interface Range and Interface VLAN modes.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
Version 2.3 Added Interface Range and Interface VLAN modes.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.