Quick Reference Guide

OSPF Commands | 435
Mode
Interface Config; Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
ip ospf hello-interval
This command sets the OSPF hello interval for the specified interface.
Syntax
ip ospf hello-interval seconds
The value for seconds is a valid positive integer, which represents the length of time in seconds. The
value for the length of time must be the same for all routers attached to a network.
Range: 1 to 65535
The no ip ospf hello-interval command sets the OSPF hello interval for the specified interface to
the default.
Default
10
Mode
Interface Config; Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
Version 2.3 Added Interface Range and Interface VLAN modes.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
ip ospf
hello-interval
Sets the OSPF hello interval for the specified interface
show ip ospf
neighbor
Displays the OSPF neighbor table list
show ip ospf
interface
Displays the information for the IFO object or virtual interface tables
Version 2.3 Added Interface Range and Interface VLAN modes.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
ip ospf
dead-interval
Sets the OSPF dead interval for the specified interface
show ip ospf
interface
Displays the information for the IFO object or virtual interface tables