Quick Reference Guide

424 | OSPF Commands
www.dell.com | support.dell.com
• ip ospf authentication-key on page 433
• ip ospf cost on page 434
• ip ospf dead-interval on page 434
• ip ospf hello-interval on page 435
• ip ospf mtu-ignore on page 436
• ip ospf priority on page 436
• ip ospf retransmit-interval on page 436
• ip ospf transmit-delay on page 437
• maximum-paths on page 438
• router-id on page 438
• router-id on page 438
• redistribute on page 438
• show ip ospf on page 439
• show ip ospf abr on page 440
• show ip ospf area on page 440
• show ip ospf database on page 441
• show ip ospf interface on page 441
• show ip ospf interface brief on page 443
• show ip ospf interface stats on page 443
• show ip ospf neighbor on page 444
• show ip ospf range on page 446
• show ip ospf stub table on page 447
• show ip ospf virtual-link on page 447
• show ip ospf virtual-link brief on page 448
• trapflags on page 448
1583compatibility
This command enables OSPF 1583 compatibility.
The oe version of this command disables OSPF 1583 compatibility.
Syntax
[no] 1583compatibility
Default
enabled
Mode
Router OSPF Config
Note: 1583 compatibility mode is enabled by default. If all OSPF routers in the
routing domain are capable of operating according to RFC 2328, OSPF 1583
compatibility mode should be disabled.