Quick Reference Guide

40 | System Management Commands
www.dell.com | support.dell.com
Command
History
Related
Commands
management route default
This command sets the IP gateway of the switch. The management IP address (configured with the ip
address, above) and the gateway must be on the same subnet.
Syntax
management route default gateway
Parameters
Use no management route default to remove the gateway.
Mode
Global Config
Command
History
Usage
Information
Use this command along with the ip address command to configure the management address of the
switch. Execute the interface managementethernet command from Global Config mode to access the
ip address command, as shown in the following example.
Example
Figure 5-5. Example of Configuring Management Address
Version 2.3
Introduced. Replaces the network mac-type
command.
interface managementethernet Invokes the Interface ManagementEthernet mode, the
(Config-if-ma)# prompt.
gateway
Valid IP address
Version 2.3 Introduced: Replaces the network parms command for the gateway part of the
management address.
Note: The IP Address and the gateway must be on the same subnet.
(s50-1) (Config)#management route default 10.10.1.254
(s50-1) (Config)#interface managementethernet
(Config-if-ma)#ip address 10.10.1.251 255.255.255.0
(Config-if-ma)#exit
(s50-1) (Config)#ip http server enable
(s50-1) (Config)#exit
(s50-1) #
(s50-1) #show interface managementethernet
IP Address..................................... 10.10.1.151
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.10.1.254
Burned In MAC Address.......................... 00:01:E8:D5:A0:39
Locally Administered MAC Address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Network Configuration Protocol Current......... None
Management VLAN ID............................. 1
Web Mode....................................... Enable
Java Mode...................................... Disable