Quick Reference Guide

ACL Commands | 389
Broadcast Storm Control Commands
This section contains the following commands:
• show storm-control
• storm-control broadcast on page 390
• storm-control flowcontrol on page 390
show storm-control
This command displays switch configuration information.
Syntax
show storm-control [unit/slot/port | all]
Mode
Privileged Exec
Defaults Broadcast Storm Recovery Mode—May be enabled or disabled. The factory default is disabled.
802.3x Flow Control Mode—May be enabled or disabled. The factory default is disabled.
Example
Figure 21-126. Command Example: show storm-control
Related
Commands
Force10-S50 #show storm-control
802.3x Flow Control Mode....................... Disable
Force10-S50 #show storm-control 1/0/1
Bcast Bcast Mcast Mcast Ucast Ucast
Intf Mode Level Mode Level Mode Level
------ ------- ------- ------- ------- ------- -------
1/0/1 Disable 5 Disable 5 Disable 5
Force10-S50 #show storm-control all ?
<cr> Press enter to execute the command.
Force10-S50 #show storm-control all
Bcast Bcast Mcast Mcast Ucast Ucast
Intf Mode Level Mode Level Mode Level
------ ------- ------- ------- ------- ------- -------
1/0/1 Disable 5 Disable 5 Disable 5
1/0/2 Disable 5 Disable 5 Disable 5
1/0/3 Disable 5 Disable 5 Disable 5
1/0/4 Disable 5 Disable 5 Disable 5
1/0/5 Disable 5 Disable 5 Disable 5
1/0/6 Disable 5 Disable 5 Disable 5
1/0/7 Disable 5 Disable 5 Disable 5
1/0/8 Disable 5 Disable 5 Disable 5
1/0/9 Disable 5 Disable 5 Disable 5
!-----------output truncated---------------!
storm-control broadcast Configure storm control.
show interface ethernet
The report generated by the
show interface ethernet command
contains broadcast storm statistics.