Quick Reference Guide

36 | System Management Commands
www.dell.com | support.dell.com
• show interfaces on page 59
• show logging on page 60
• show mac-addr-table on page 61
• show memory on page 63
• show msglog on page 63
• show network on page 64
• show process cpu on page 64
• show running-config on page 65
• show sysinfo on page 66
• show version on page 69
• show tech-support on page 68
See also the show commands in the logging chapter, System Logs on page 169.
cx4-cable-length
Configure the length of the cable to be connected to the selected CX4 port.
Syntax
[no] cx4-cable-length {long | medium | short}
Parameters
Default
medium
Mode
Interface Config
Command
History
Example
Figure 5-3. Example of CX4 Cable Length Configuration
long | medium | short
Enter the keyword that matches the cable length to be used at the selected
port:
short = 60cm, 1m, and 3m
medium = 5m
long = 10m, 15m
Version 2.5.1 Introduced
Force10 #config
Force10 Config#interface config 1/0/49
Force10 (Interface 1/0/49)# cx4-cable-length long
Force10 (Interface 1/0/49)#exit
Force10 Config#interface config 1/0/50
Force10 (Interface 1/0/50)#no cx4-cable-length
Force10 (Interface 1/0/50)#exit
Force10 Config#exit
Force10 #show cx4-cable-length
Interface CX4 Cable Length Setting
--------- ------------------------
1/0/49 long
1/0/50 medium
Force10 #