Quick Reference Guide

LAG/Port Channel Commands | 301
port-security
This command is available in the Interface Port Channel Config mode.
See port-security on page 183 in the Security Commands chapter.
port-security mac-address
This command is available in the Interface Port Channel Config mode.
See port-security mac-address on page 184 in the Security Commands chapter.
port-security mac-address move
This command is available in the Interface Port Channel Config mode.
See port-security mac-address move on page 184 in the Security Commands chapter.
port-security max-dynamic
This command is available in the Interface Port Channel Config mode.
See port-security max-dynamic on page 185 in the Security Commands chapter.
port-security max-static
This command is available in the Interface Port Channel Config mode.
See port-security max-static on page 185 in the Security Commands chapter.
protocol lacp
This command reenables the LACP on the selected LAG.
Syntax
protocol lacp
Default
enabled
Mode
Interface Port Channel Config
Usage
By default, LACP is enabled, but, if the LAG has been converted to static, you can use this command
to revert the LAG to LACP mode.
Command
History
Version 2.5.1 Introduced, in the new Interface Port Channel Config mode, to replace
port-channel staticcapability.
Related
Commands
interface port-channel Accesses the Interface Port Channel Config mode for the selected port
channel.