Quick Reference Guide

LAG/Port Channel Commands | 299
port-channel name
This command defines a name for the port channel (LAG).
Mode
Global Config
Command
History
port-channel staticcapability
This command enables the support of port channels (static link aggregations - LAGs) on the device. By
default, the static capability for all port channels is disabled.
Command
History
port lacpmode enable
This command enables Link Aggregation Control Protocol (LACP) on a port.
The no version of this command disables LACP on a port.
Syntax
[no] port lacpmode enable
Default
disabled
Mode
Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as
(conf-if-range-vlan 10-20)#.
Command
History
port lacpmode enable all
This command enables Link Aggregation Control Protocol (LACP) on all ports.
The no version of this command disables Link Aggregation Control Protocol (LACP) on all ports.
Syntax
[no] port lacpmode enable all
Mode
Global Config
Version 2.5.1 Deprecated: Replaced by description (port channel), which adds a text description of the
port channel from the new Interface Port Channel Config mode.
Version 2.5.1 Replaced by protocol static, in the new Interface Port Channel Config mode.
Version 2.5
Deprecated. Use
protocol lacp and protocol static.
Version 2.3 Added Interface VLAN and Interface Range modes.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
protocol lacp Reenables LACP on a LAG.
protocol static Converts a LAG from LACP to static.