Quick Reference Guide

LAG/Port Channel Commands | 295
igmp mrouter
This command is available in the Interface Port Channel Config mode.
See igmp mrouter on page 277 in the IGMP chapter.
igmp mrouter interface
This command is available in the Interface Port Channel Config mode.
See igmp mrouter interface enable on page 278 in the IGMP chapter.
interface port-channel
This command invokes the Interface Port Channel Config mode, along with creating a port channel
(LAG) if one with the designated number does not exist.
The no version of this command deletes a port channel (LAG).
Syntax
[no] interface port-channelr1-128
The 1-128 field is an integer that uniquely identifies the port channel. The maximum number of
supported port channels is 128, out of which, at most, six dynamic port channels are recommended.
Mode
Global Config
Command
History
ip access-group (port channel)
This command attaches a specified access control list (ACL) to the port channel selected by the
interface port-channel command.
Syntax
ip access-group 1–199 [1-4294967295]
Note: Before including a port in a port channel, set the physical mode of the port. See the
speed command.
Version 2.5.1.0
Modified: Before 2.5.1, the command syntax was
desC6Oi ooEg name. The previous
number of supported port channels was 32.
Related
Commands
channel-member Add a port or range of ports to the selected LAG. LAG ports must be physical ports,
not other LAGs.
show interfaces
port-channel
Displays an overview of all port channels (LAGs) on the switch or details on the
selected LAG.
speed Set the physical mode of the port.