Quick Reference Guide

290 | LAG/Port Channel Commands
www.dell.com | support.dell.com
classofservice dot1p-mapping
See classofservice dot1p-mapping on page 328 in the QoS chapter.
clear port-channel
This command removes all currently configured port-channels (LAGs).
Syntax
clear port-channel
Mode
Privileged Exec
cos-queue max-bandwidth
This command specifies the maximum transmission bandwidth limit for each interface queue. Also
known as rate shaping, this has the effect of smoothing temporary traffic bursts over time so that the
transmitted traffic rate is bounded. The total number of queues supported per interface is platform
specific.
Syntax
Oen6HWEWEu, G6r o.Aa.Ciu<bw-0> <bw-1> … <bw-n>
Modes
Global Config and Interface Config
no cos-queue max-bandwidth
This command restores the default for each queue's maximum bandwidth value.
Syntax
no cos-queue max-bandwidth
Mode
Global Config and Interface Config
cos-queue min-bandwidth
See cos-queue min-bandwidth on page 330 in the QoS chapter.
Related
Commands
cos-queue max-bandwidth Deletes the selected port from the specified logical interface.
interface port-channel Creates the port channel (LAG) or, if the port channel is already created,
invokes the Interface Port Channel Config mode.
show interfaces port-channel Displays an overview of all port channels (LAGs) on the switch or details on
the selected LAG.