Quick Reference Guide

IGMP Snooping Commands | 279
Related
Commands
set igmp fast-leave
Command
History
Related
Commands
set igmp groupmembership-interval (system level)
This command sets the IGMP Group Membership Interval time on the system. The Group Membership
Interval time is the amount of time in seconds that a switch will wait for a report from a particular
group on a particular interface before deleting the interface from the entry. This value must be greater
than the IGMP Maximum Response time value.
Syntax
[no] set igmp groupmembership-interval 2-3600
The range is 2 to 3600 seconds.
The no version of this command sets the IGMP Group Membership Interval time on the system to 260
seconds.
Default
260
Mode
Global Config
Related
Commands
set igmp groupmembership-interval (interface level)
Command
History
Related
Commands
igmp enable (global) Enables IGMP Snooping on the system.
igmp enable
(interface)
Enables IGMP Snooping on a selected interface.
Version 2.3
Revised to
igmp fast-leave.
igmp fast-leave Enables or disables IGMP Snooping fast-leave admin mode on a selected interface.
igmp enable (global) Enables IGMP Snooping on the system.
igmp enable (global) Enables IGMP Snooping on the system.
show igmpsnooping Displays IGMP Snooping status information.
Version 2.3
Revised to
igmp groupmembership-interval (interface level).
igmp groupmembership-interval Sets the IGMP Group Membership Interval time on a particular
interface.
igmp enable (interface) Enables IGMP Snooping on a selected interface.